Modeling and Simulink of METAPRISM PASSIVE METASURFACES REVOLUTIONIZING OFDM BEAM CONTROL
Implementation plan:
—————————————
Step 1: Initially we construct a network consist of 20-User nodes, 1-Base Station, 2-Metaprism surface.
Step 2: Next, we load the parameters such as carrier frequency, bandwidth, modulation scheme and number of subcarriers.
Step 3: Next, we implement OFDM into our network.
Step 4: Next, we create a channel to incorporate path loss for non-line-of-sight (NLOS) conditions.
Step 5: Then, we implement optimization algorithms to fine-tune metaprism parameters.
Step 6: Next, we use Mante Carlo simulation to simulate the system.
Step 7: Finally we plot graphs for the following:
7.1: Bit Error Rate(BER)
7.2: Energy Consumption
7.3: Spectral Efficiency
7.4: Latency
Software Requirement:
——————————-
1) Matlab R2020a or above
2) Windows 10 [64-bits]
Note:
———
1) If the above plan does not satisfy your requirement, please provide the processing details, like the above step-by-step.
2) Please note that this implementation plan does not include any further steps after it is put into implementation.
